5/16/2023 0 Comments Usenetic add server disabled![]() In Server name, enter the full-qualified domain name of the server you want to add, click Add, then click Add again at the bottom.Under Servers, select the Inventory tab.Under Cluster connections, select the cluster.In Windows Admin Center, select Cluster Manager from the top drop-down arrow.Use Windows Admin Center to join the server to your cluster. For detailed information, see Deploy Azure Stack HCI. Install the Azure Stack HCI operating system on the new server.Run OEM validation tests to ensure hardware homogeneity with the existing clustered servers.Apply the current firmware baseline to all components by using the tools that are provided by your OEM.Configure the correct IP address in the baseboard management controller (BMC) and apply all BIOS settings per OEM instructions.Enable physical switch ports and adjust access control lists (ACLs) and VLAN IDs if applicable.Place the new physical server in the rack and cable it appropriately.Always refer to your OEM-provided documentation when adding new server hardware for use in your cluster. The first step is to acquire new HCI hardware from your original OEM. This applies to both non-stretched and stretched clusters. Whenever you add or remove a server, you must also perform cluster validation afterwards to ensure the cluster is functioning normally. Keep in mind that each new physical server must closely match the rest of the servers in the cluster when it comes to CPU type, memory, number of drives, and the type and size of the drives. You can easily add or remove servers from a cluster in Azure Stack HCI. Applies to: Azure Stack HCI, versions 22H2, 21H2, and 20H2
0 Comments
Leave a Reply. |